PDA

View Full Version : [CUSTOM] Scourge-ifying Nemesis Prime


Clay
2008-11-20, 02:23 AM
I've been playing the Dremel again, trying to make the Ram match the body type of the G2 Prime figure a bit more. Will probably want to add more teal and gray too, but I'm not sassed about painting anything yet.

Pictures aren't terribly flattering at the moment, but I'll fool with that later. This so a back burner project.

robot mode w/hood shield (http://i50.photobucket.com/albums/f303/claywyatt1982/kitbash/PB180031.jpg)

hood/shield stowed! (http://i50.photobucket.com/albums/f303/claywyatt1982/kitbash/PB180032.jpg)

The truck is unharmed! (http://i50.photobucket.com/albums/f303/claywyatt1982/kitbash/PB180034.jpg)

Springer007
2008-11-20, 03:48 AM
I've been playing the Dremel again, trying to make the Ram match the body type of the G2 Prime figure a bit more. Will probably want to add more teal and gray too, but I'm not sassed about painting anything yet.

Pictures aren't terribly flattering at the moment, but I'll fool with that later. This so a back burner project.

robot mode w/hood shield (http://i50.photobucket.com/albums/f303/claywyatt1982/kitbash/PB180031.jpg)

hood/shield stowed! (http://i50.photobucket.com/albums/f303/claywyatt1982/kitbash/PB180032.jpg)

The truck is unharmed! (http://i50.photobucket.com/albums/f303/claywyatt1982/kitbash/PB180034.jpg)

I imagine I asked this earlier, but how do you do the grill and front end cap as the chest so well? Any instructions? I so want to do this to Prime to Springer-rize him more now.......