PDA

View Full Version : [CUSTOM] PRiD Vehicon Articulation Improvement


Paul053
2012-11-21, 02:41 PM
Here are some tips for improving the already pretty good PRiD Vehicon.

See the top panel on each leg? Cut in as much as you can. That will allow the knee to bend more.
https://sites.google.com/site/tflocation/home/tfimages/vehicon/Vehicon-1.jpg

Now the left leg can bend at more angles than right.
https://sites.google.com/site/tflocation/home/tfimages/vehicon/Vehicon-2.jpg

https://sites.google.com/site/tflocation/home/tfimages/vehicon/Vehicon-3.jpg

Cut this little piece out at the bottom of the car. This will give the wheel panel clearance to rotate all the way down.
https://sites.google.com/site/tflocation/home/tfimages/vehicon/Vehicon-4.jpg

I kind of don't like the angle his elbow was formed. So I cut out another hole on the ball joint socket (on the right), that can make the arm more straight.
https://sites.google.com/site/tflocation/home/tfimages/vehicon/Vehicon-5.jpg

Done!
https://sites.google.com/site/tflocation/home/tfimages/vehicon/Vehicon-9.jpg

And don't toss him away if you don't like him.:D
https://sites.google.com/site/tflocation/home/tfimages/vehicon/Vehicon-12.jpg